Stress-Strength Analysis in Design for Reliability: Difference between revisions

From ReliaWiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 20: Line 20:
The above result shows that the current reliability is about 74.05%, which is below the target value of 90%. We need to use the '''Target Reliability Parameter Estimator''' to determine the parameters for the strength distribution that would be required to meet the target. Click the following icon:
The above result shows that the current reliability is about 74.05%, which is below the target value of 90%. We need to use the '''Target Reliability Parameter Estimator''' to determine the parameters for the strength distribution that would be required to meet the target. Click the following icon:


[[Image:Stress-strength example 2 target R icon.png|thumb|center|250px]]
[[Image:Stress-strength example 2 target R icon.png|center]]





Revision as of 23:46, 25 April 2012

Using Stress-Strength Analysis to Determine the Required Strength Distribution

Assume the stress distribution for a component is known and it is a Weibull distribution with beta=3 and eta=2000. For the current design, the strength distribution is also a Weibull distribution with beta =1.5 and eta=4000.

• Evaluate the current reliability.
• If the reliability does not meet the target reliability of 90%, determine what parameters would be required for the strength distribution in order to meet the specified target.


Solution

First, we need to create two empty Weibull++ standard folios and enter the distribution parameters for the stress and strength distributions. For example, for the stress distribution, it is:

Stress Distribution Example 2.png


Then, we use the Stress-Strength tool to compare the two data sheets. The following figure shows the reliability of the current design:

Stress-strength example 2 current reliability.png

The above result shows that the current reliability is about 74.05%, which is below the target value of 90%. We need to use the Target Reliability Parameter Estimator to determine the parameters for the strength distribution that would be required to meet the target. Click the following icon:

Stress-strength example 2 target R icon.png


Choose to calculate for eta under Strength Parameters, set the Target Reliability to 90% and click Calculate:

Stress-strength example 2 Result.png


The calculated eta is 8192.2385 hours. Click Update to perform the stress-strength analysis again using the altered parameters for the strength distribution.

The plot shows the calculated reliability indeed is 90%.

Stress-strength example 2 Confirmed Result.png


Therefore, in order to meet the reliability requirement, the component must be redesigned with the eta to be at least 8192.2385 hours.