Template:Reliability test design: Difference between revisions

From ReliaWiki
Jump to navigation Jump to search
No edit summary
(Redirected page to Reliability Test Design)
 
(4 intermediate revisions by 3 users not shown)
Line 1: Line 1:
Quite often, there is a desire to design reliability demonstration tests that have few or no failures. These tests are often required to demonstrate customer reliability and confidence requirements. While it is desirable to be able to test a large population of units to failure in order to obtain information on a product or design's reliability, time and resource constraints sometimes make this impossible. In cases such as these, a test can be run on a specified number of units, or for a specified amount of time, that will demonstrate that the products have met or exceeded a given reliability at a given confidence level. In order to do so without a large amount of cumulative test time or failure data, it is necessary to make assumptions about the failure distribution of the product. In the final analysis, the actual reliability of the units will of course remain unknown, but the reliability engineer will be able to state that certain specifications have been met.
#REDIRECT [[Reliability Test Design]]
 
{{demonstration test design}}
 
{{constant failure rate/chi-squared test design}}
 
{{bayesian test design}}
 
{{expected failure time plots}}
 
{{difference detection matrix}}
 
{{Test Design Using SimuMatic}}

Latest revision as of 08:02, 29 June 2012