Search results

{{Reference Example|{{Banner RGA Reference_Examples}}|Test-Find-Test Data}} This example validates the results for test-find-test data in RGA.

...ing|"C:\RSRepository1.rsr11"}}){{APIComment|'Replace with name and path to test repository.}} ...ry.Project.SetCurrentProject(1){{APIComment|'Replace with the object ID of test project.}}

...> and <math>{{T}_{4}}=100000\,\!</math>. The average fix delay in terms of test hours for each phase is: <math>{{L}_{1}}=10000\,\!</math>, <math>{{L}_{2}}= ...gram was initiated and actual test data from phase 1 is now available. The test data were analyzed using the Crow Extended - Continuous Evaluation model an

{{Reference Example|{{Banner RGA Reference_Examples}}|Test-Fix-Find-Test Data}} This example validates the results for test-fix-find-test data in RGA.

Consider the following test data, as shown in the following Table B.1.

...include>shown in the [[Test-Find-Test_Data_Example|Crow Extended Test-Find-Test Data example]]</noinclude><includeonly>given above</includeonly>.

...that the two accelerated bend stresses are 90º and 180º. For the 90º bend, test the paper clip using the following procedure. Use a similar procedure for t '''Paper Clip Test'''

#What is the rate at which unique BD modes are being generated during this test? #If the test continues for an additional 50 hours, what is the minimum number of new uni

==Common Beta Hypothesis Test== ...rences|[17]]], suppose that <math>K\,\!</math> number of systems are under test. Each system has an intensity function given by:

...a test, we must determine the sample size to test as well as the expected test duration. The next simple example illustrates the methods available in Simu ...ed until we arrive at an acceptable test design (i.e., number of units and test duration).

...cenarios where a major change occurs during a reliability growth test. The test data can be broken into two segments with a separate Crow-AMSAA (NHPP) mode Consider the data in the following plot from a reliability growth test.

...test consisted of 15 runs. The following table presents the data from the test. Find the Logistic model that best fits the data set, and plot it along wit ...that the test starts when the reliability is not equal to zero or one. The test essentially begins at time 1, and is now considered as time 0 with <math>N=

...es obtained from a reliability growth test of a newly designed system. The test has a duration of 660 hours. <center>Failure Times From a Reliability Growth Test</center>

...g the second month, two prototypes were tested for a total of 250 hours of test time. The next table shows the successive <math>N=86\,\!</math> failure tim <li>For the time terminated test:

...ze in the test using SimuMatic. The accelerated test will be a temperature test at 350K, 375K and 400K with a use temperature of 300K. The Arrhenius model The next step is to determine the stress levels and the allocated test units at each level. The engineer chooses to start the analysis with a samp

|+'''Success/Failure Data for a Variable Number of Tests Performed in Each Test Stage''' !Test Stage Number(<math>k\,\!</math>)

...MyControl {{APIPrefix|As New}} cXfmeaControl({{APIString|"Lamp durability test #456"}})

...led action record. Enables the use of additional properties for describing test plans.

|+'''Developmental Test Data''' !Test Time Unit 1(hours)

<li>Experiment with the impact of sample size, test time and growth parameters on analysis results. ...where the termination time needs to be specified, or a failure terminated test, where the number of failures needs to be specified. The generated failure